Test Terminating Trunk Transmission; Test The C-Lan Connectivity - Avaya S8700 Installing Manual

316
Testing the Complete Configuration

Test Terminating Trunk Transmission

The Terminating Trunk Transmission Test provides for extension number access to 3 tone
sequences that can be used for trunk transmission testing from the distant end of the trunks.
Type change system-parameters maintenance and press
1
2 Under TERMINATING TRUNK TRANSMISSION TEST ( Extension ), type in 3
extension numbers in the 3 fields provided:
Test Type 100:_______Test Type 102:_______Test Type 105:_______
Test Type
Test type 100
Test Type
102
Test Type
105

Test the C-LAN Connectivity

To test the external IP connections, ping the C-LAN circuit pack and ping a known
1
computer connected to your network. If everything is configured correctly, the Result
column on the Ping Results screen reads PASS. If it reads ABORT, verify the IP-address
information and check the connectivity, including the cabling.
To ping the C-LAN server, type ping ip-address IPaddress board UUCSS and press
2
Enter.
The variable IPaddress is the IP address of the TN799DP C-LAN circuit pack and
UUCSS is the cabinet, carrier, and slot of the TN799DP C-LAN circuit pack.
3 Type ping ip-address IPaddress board UUCSS and press
The variable IPaddress is the IP address of another computer beyond the gateway and
UUCSS is the cabinet, carrier, and slot of the TN799DP C-LAN circuit pack.
Test Features
5.5 seconds of 1004 Hz tone at 0 dB
Quiet until disconnect; disconnect is forced after 1 minute
9 seconds of 1004 Hz tone at 0 dB
1 second of silence
Cycle is repeated until disconnect, which is forced after 24
hours
9 seconds of 1004 Hz tone at -16 dB
1 second of silence
9 seconds of 404 Hz tone at -16 dB
1 second of silence
9 seconds of 2804 Hz tone at -16 dB
30 seconds of silence
0.5 seconds of test progress tone (2225 Hz)
About 5 seconds of silence
Forced disconnect
October 2002
and go to screen 2.
Enter
Enter.