Specifications - Toro 75930 Operator's Manual

Blade-Control Switch (Power
Takeoff)
The blade-control switch (PTO) engages and
disengages power to the mower blades
Ignition Switch
Use this switch to start the mower engine. It has 3
positions: S , R , and O
TART UN
Motion-Control Levers
Use the motion-control levers to drive the machine
forward, reverse, and turn either direction.
Neutral-Lock Position
Use the N -
EUTRAL LOCK
safety-interlock system to engage and to determine
the N position.
EUTRAL
Fuel-Shutoff Valve
Close the fuel-shutoff valve (under the seat) when
transporting or storing the mower.
Electronic-Control Unit
Malfunction-Indicator Light
The electronic-control unit (ECU) continuously
monitors the operation of the EFI system.
If a problem or fault within the system is detected, the
malfunction-indicator light (MIL) illuminates.
The MIL is the red light located in the right console
panel.
Once the MIL illuminates, make initial troubleshooting
checks; refer to the MIL section under
(page 71).
If these checks do not correct the problem, further
diagnosis and servicing by an Authorized Service
Dealer is necessary.
Attachments/Accessories
A selection of Toro approved attachments and
accessories is available for use with the machine to
enhance and expand its capabilities. Contact your
Authorized Service Dealer or Distributor or go to
www.Toro.com for a list of all approved attachments
and accessories.
(Figure
.
FF
position with the
Troubleshooting

Specifications

Note:
Specifications and design are subject to
change without notice.
5).
Width
Without Deck
Deflector Up
Deflector Down
Length
Roll Bar Up
Roll Bar Down
Height
Roll Bar Up
179 cm (71 inches)
Weight
Weight
14
135 cm (53 inches)
157 cm (62 inches)
192 cm (76 inches)
211 cm (83 inches)
215 cm (85 inches)
Roll Bar Down
127.8 cm (50.3 inches)
587 kg (1,295 lb)