Speedometer Sensor Installation - Toro Reelmaster 5100-D Service Manual

Speedometer Sensor Installation

To install speedometer sensor:
1. If axle cover plate was not removed, go to step 9.
2. Lubricate and install O-ring into plate.
3. Apply silicone sealant to face of plate where it will
contact cover.
4. Install plate to inside face of cover, then install cap­
screw and lockwasher through cover into plate.
5. Install machine screw throught plate and cover, then
install locknut to machine screw.
6. Tighten capscrew and locknut to secure plate to
cover.
7. Install jam nut onto long machine screw until near
lock nut.
8. Install plate and cover assembly to axle assembly
using silicone sealant to seal cover to axle, then install
eight (8) screws to secure cover.
9. Lubricate and install O-ring if not done in step 2
above.
10. Insert sensor into hole in cover with hole in sensor
going over long machine screw, and push sensor in
until it contacts axle gear.
11. Thread jam nut out until is contacts sensor. Turn jam
nut one more turn out from this point (this pulls sensor
out slightly).
12. Install other locknut to machine screw and tighten to
secure sensor in position.
®
Reelmaster 5100-D
4
1
8
6
7
5
1. O-ring
2. Plate
3. Cover
4. Capscrew & lockwasher
Page 5 - 45
1
Figure 59A
1. Speedmeter sensor
Figure 59B
5. Machine screw
6. Locknut (2)
7. Jam nut
8. Sensor
3
2
Repairs