Table of Contents
Advertisement
User Guide
3.2.1 Fan Module Replacement
Important: If more than one Fan Module has failed, each Fan Module must be replaced one
at a time. Replacing more than one Fan Module at a time may cause the enclosure to go into
thermal shutdown.
Table 30: Replacement Procedure Info
Required Tools
None
Step 1 : Unpack and inspect the new Fan Module for damage.
a. Inspect the packaging that the Fan Module replacement was shipped in and record any
b. Remove the Fan Module from the packaging and verify that there is no damage to the
c. Store in a safe location until the Fan Module is needed for installation.
Step 2 : Uninstall the Fan Module from the enclosure.
a. From the rear of the rack, unlock the Fan Module by turning the thumbscrew
b. Pull the release handle out until the Fan Module is unseated and can be removed from
Part Name
Chassis
damage to the box. Large cuts, open boxes, and crushed corners should be reported.
Fan Module. Dents, scratches, and broken parts should be reported. If major damage has
occurred to the Fan Module, DO NOT use the replacement part.
counterclockwise until the screw threads are not engaged any longer. The location of
the thumbscrew is shown in the following image.
Figure 93: Fan Module Release Handle Unlocked
the fan bay.
# of People Required
1
3. Management
3.2 Part Replacement
Replacement Time
60 minutes
Time Required
2 minutes
82
Advertisement
Table of Contents
