Western Digital OpenFlex F3100 User Manual page 120

User Guide
Table 35: Replacement Procedure Info
Required Tools
#2 Phillips Head screwdriver
Step 1 : Unpack and inspect the new Chassis for damage.
a. Inspect the packaging that the Chassis replacement was shipped in and record any
damage to the box. Large cuts, open boxes, and crushed corners should be reported.
b. Remove the Chassis from the packaging and verify that there is no damage to the
Chassis. Dents, scratches, and broken parts should be reported. If major damage has
occurred to the chassis, DO NOT use the replacement part.
c. Store in a safe location until the Chassis is needed for installation.
Step 2 : Disconnect the power and data cables from the enclosure.
Figure 153: Enclosure Power and Data Connections
a. Move to the rear of the rack and open the cable retention clip on both of the PSUs and
disconnect the power cables from each of the two PSUs.
# of People Required
2
3. Management
3.2 Part Replacement
Time Required
60 minutes
114