Western Digital OpenFlex F3100 User Manual page 123

User Guide
c. Uninstall the remaining PSU in the same way the first was uninstalled.
Step 5 : (Optional) Uninstall the device blanks from the enclosure.
a. From the front of the rack, press the release button on the front of the device blank. The
release handle will eject outward.
b. Use the release handle to pull the device blank out of the enclosure part way. Then grasp
the device blank from the underside to support it as you pull it the rest of the way out of
the enclosure.
Attention: This step is optional because not all configurations contain device
blanks. If the configuration contains a device blank, this step will be required.
Blanks must be installed in any empty slots to ensure proper cooling.
Figure 159: Device Blank Release Operation
3. Management
3.2 Part Replacement
117