Western Digital OpenFlex F3100 User Manual page 137

User Guide
d. Verify that the device blank is securely latched into the chassis by pulling on the release
handle and ensuring the device blank does not move when pulled. Reinstall the device
blank if it is not securely installed into the chassis.
e. Install each device blank in the same way the first was installed.
Step 13 : Install the PSUs into the enclosure.
a. Move to the rear of the rack, orient the PSU with the power socket located on the
bottom and insert it into the PSU slot.
b. Verify that the PSU is fully seated and latched into the PSU slot by gently pulling on the
handle.
c. Install the remaining PSU in the same way the first was installed.
Step 14 : Install the Fan Modules into the enclosure.
Figure 185: Secure Device Blank
Figure 186: PSU Installation
3. Management
3.2 Part Replacement
131