Table of Contents
Advertisement
User Guide
d. Verify that the F3100 is securely latched into the chassis by pulling on the latch and
3.2.5 Rails Replacement
Table 34: Replacement Procedure Info
Required Tools
T15 Torx screwdriver
Step 1 : Unpack and inspect the new Rack Mount Rails for damage.
a. Inspect the packaging that the Rack Mount Rails replacement was shipped in and
b. Remove the Rack Mount Rails from the packaging and verify that there is no damage to
c. Store in a safe location until the Rack Mount Rails is needed for installation.
Step 2 : Disconnect the power and data cables from the enclosure.
Figure 117: Secure OpenFlex F3100
ensuring the device does not move when pulled. Reinstall the device if it is not securely
installed into the chassis.
Note: The blue and yellow LEDs will illuminate followed shortly by the
green LED. All three LEDs will remain illuminated for just over a minute
until the device is initialized. Once the device are initialized, the yellow
and blue LEDs will turn off and the Device Status LED that encircles the
device release button will illuminate indicating that the SPDK services
are running. Wait time is not required between the installation of
multiple OpenFlex F3100 devices.
record any damage to the box. Large cuts, open boxes, and crushed corners should be
reported.
the Rack Mount Rails. Dents, scratches, and broken parts should be reported. If major
damage has occurred to the Rack Mount Rails, DO NOT use the replacement part.
# of People Required
2
3. Management
3.2 Part Replacement
Time Required
65 minutes
95
Advertisement
Table of Contents
