Western Digital OpenFlex F3100 User Manual page 135

User Guide
Step 12 : (Optional) Install the device blanks into the enclosure.
a. Press the release button on the front of the OpenFlex F3100 . The release handle will
eject outward.
b. Gently slide the device blank into a chassis device blank slot until the release handle is
engaged with the chassis. When the handle lifts up slightly, it is an indicator that the
release handle is engaged with the chassis.
Figure 181: OpenFlex F3100 Slot Identification
Attention: This step is optional because not all configurations contain device
blanks. If the configuration contains a device blank, this step will be required.
Blanks must be installed in any empty slots to ensure proper cooling.
Figure 182: OpenFlex F3100 Release Operation
3. Management
3.2 Part Replacement
129