Western Digital OpenFlex F3100 User Manual page 139

User Guide
d. Verify that the Fan Module is securely latched into the chassis by pulling on the release
handle and ensuring the Fan Module does not move when pulled. Reinstall the Fan
Module if it is not securely installed into the chassis.
e. Install each Fan Module in the same way the first was installed.
Step 15 : Power up the E3000.
Figure 190: Enclosure Power and Data Connections
a. Connect the power cables into each of the PSUs at the rear of the unit. The BMC Module,
PSUs, and Fan Modules should all power on.
b. Verify the LEDs are illuminated on the PSUs.
c. Tighten the cable retention clips by sliding the retention clip forward on the PSUs until it
stops near the cable connectors. Doing this will ensure that the retention clips function
properly in the event the cable is pulled on.
Figure 189: Fan Module Secure
3. Management
3.2 Part Replacement
133