Western Digital OpenFlex F3100 User Manual page 115

User Guide
f. Install each device in the same way the first was installed, and be sure to follow the
installation order depicted in the following figure.
Step 10 : (Optional) Install the device blanks into the enclosure.
a. Press the release button on the front of the OpenFlex F3100 . The release handle will
eject outward.
Note: The blue and yellow LEDs will illuminate followed shortly by the
green LED. All three LEDs will remain illuminated for just over a minute
until the device is initialized. Once the device are initialized, the yellow
and blue LEDs will turn off and the Device Status LED that encircles the
device release button will illuminate indicating that the SPDK services
are running. Wait time is not required between the installation of
multiple OpenFlex F3100 devices.
Figure 144: OpenFlex F3100 Slot Identification
Attention: This step is optional because not all configurations contain device
blanks. If the configuration contains a device blank, this step will be required.
Blanks must be installed in any empty slots to ensure proper cooling.
3. Management
3.2 Part Replacement
109