Western Digital OpenFlex F3100 User Manual page 95

User Guide
a. Inspect the packaging that the BMC Module replacement was shipped in and record any
damage to the box. Large cuts, open boxes, and crushed corners should be reported.
b. Remove the BMC Module from the packaging and verify that there is no damage to the
BMC Module. Dents, scratches, and broken parts should be reported. If major damage
has occurred to the BMC Module, DO NOT use the replacement part.
c. Store in a safe location until the BMC Module is needed for installation.
Step 2 : Uninstall the BMC Module from the enclosure.
a. From the front of the rack, grasp the release handle with your forefinger on the bottom
and thumb on the top of the release latch and press the release latch with your thumb.
The handle will eject from the front of the BMC Module.
b. Lower the release handle until the BMC module is fully unseated (this occurs at about
60°) and pull the BMC module out of the chassis ensuring that you support the under
side of the BMC module with your other hand.
Figure 105: BMC Module Release Handle Operation
Figure 106: Uninstall BMC Module
3. Management
3.2 Part Replacement
89