User Guide
d. From the front of the rack, use the T15 Torx screwdriver to install the flat head T15 screws
to secure the rail to the vertical rack rails.
e. Install the remaining rail in the same way the first was Installed.
f. The following must be completed to verify that the rails have been properly installed:
Step 8 : Install the Chassis into the rack.
a. Carefully slide the chassis onto the rails until the chassis mounts are flush with the
mounts on the rails.
Figure 134: Rear Rack Mount Rail Screw Installation
Figure 135: Front Rack Mount Rail Screw Installation
• Both rails have been installed into the rack unit space and are level
• Both of the front rails contain one T15 screw in each rail mount
• Both of the rear rails contain two T15 screw in each rail mount
Tip: A T15 Torx screwdriver is required for this step.
3. Management
3.2 Part Replacement
104