Western Digital OpenFlex F3100 User Manual page 91

User Guide
Table 31: Replacement Procedure Info
Required Tools
None
Step 1 : Unpack and inspect the new PSU for damage.
a. Inspect the packaging that the PSU replacement was shipped in and record any damage
to the box. Large cuts, open boxes, and crushed corners should be reported.
b. Remove the PSU from the packaging and verify that there is no damage to the PSU.
Dents, scratches, and broken parts should be reported. If major damage has occurred to
the PSU, DO NOT use the replacement part.
c. Store in a safe location until the PSU is needed for installation.
Step 2 : Disconnect the power cable from the failed PSU.
Figure 98: Enclosure Power and Data Connections
a. Move to the rear of the rack and open the cable retention clip on the PSU and
disconnect the power cable from the PSU.
# of People Required
1
3. Management
3.2 Part Replacement
Time Required
3 minutes
85