Western Digital OpenFlex F3100 User Manual page 108

User Guide
c. Remove the rails from the rack by sliding the rail mounts out of the vertical rack rail. The
rail uses a spring loaded mechanism to secure the rails into the rack before securing
them with the provided screws.
d. Uninstall the remaining rail in the same way the first was Uninstalled.
Step 7 : Install the new Rack Mount Rails.
a. Determine which of the rails is the right and which is the left. From the front of the rack,
the rails will need to be installed into the right and left sides. The front of the rail can be
identified by the single rack mount pin and the rear of the rail can be identified by the
two rack mount pins as shown in the following image. Another way to orient the rails
correctly is to make sure that the shelf-flanges that support the enclosure are facing the
inside of the rack where the enclosure will reside.
Figure 130: Front Rack Mount Rail Screw Removal
Figure 131: Rack Mount Rail Removal
Tip: A T15 Torx screwdriver with torque measuring capabilities is recommended
for this step.
3. Management
3.2 Part Replacement
102