Western Digital OpenFlex F3100 User Manual page 102

User Guide
Figure 118: Enclosure Power and Data Connections
a. Move to the rear of the rack and open the cable retention clip on both of the PSUs and
disconnect the power cables from each of the two PSUs.
b. Disconnect the Ethernet Cable from the Ethernet Management port.
c. Disconnect the QSFP28 Ethernet cables from all of the QSFP28 ports.
Step 3 : (Optional) Uninstall the device blanks from the enclosure.
a. From the front of the rack, press the release button on the front of the device blank. The
release handle will eject outward.
Figure 119: Cable Retention Clip Operation
Attention: This step is optional because not all configurations contain device
blanks. If the configuration contains a device blank, this step will be required.
Blanks must be installed in any empty slots to ensure proper cooling.
3. Management
3.2 Part Replacement
96