User Guide
b. Verify that the PSU is fully seated and latched into the PSU slot by gently pulling on the
handle.
c. Install the remaining PSU in the same way the first was installed.
Step 12 : Install the Fan Modules into the enclosure.
a. Unlock the Fan Module by turning the thumbscrew counterclockwise until the screw
threads are not engaged any longer. The location of the thumbscrew is shown in the
following image.
b. Gently slide the Fan Module into the fan bay until the release handle is engaged with
the chassis. When the handle lifts up slightly, it is an indicator that the release handle is
engaged with the chassis.
Figure 149: PSU Installation
Figure 150: Prepare Fan Module
3. Management
3.2 Part Replacement
112