Western Digital OpenFlex F3100 User Manual page 117

User Guide
c. Lift the release handle up and press it into the device blank to secure it into the slot.
d. Verify that the device blank is securely latched into the chassis by pulling on the release
handle and ensuring the device blank does not move when pulled. Reinstall the device
blank if it is not securely installed into the chassis.
e. Install each device blank in the same way the first was installed.
Step 11 : Install the PSUs into the enclosure.
a. Move to the rear of the rack, orient the PSU with the power socket located on the
bottom and insert it into the PSU slot.
Figure 147: Release Handle Engage
Figure 148: Secure Device Blank
3. Management
3.2 Part Replacement
111