Rails Installation - Western Digital Ultrastar Data102 Installation Manual

Installation Guide
Step 1 : Attach a cable tie mount to the cable tray.
a. Clean the surface of the cable tray, under the mounting area, with isopropyl alcohol and
allow to dry.
b. Adhere a cable tie mount in the approximate location shown in the following diagram:
Figure 14: Cable Tie Mount Location
Step 2 : Secure the cable tray onto the enclosure using the included M3 x 8mm T10 Torx screws and the
Long T10 Torx Screwdriver. These screws should be tightened to .33-.56 Nm / 3-5 in-lbf.
Figure 15: Installing the Cable Tray
W hat to do next: T he cable tray is now installed. Proceed to
5.2 Cable Tray Installation (Optional)
Rails Installation (page 38).
5. Installation
38