Start-Up Flowcharts - YASKAWA A1000 Series Quick Start Manual

4 Start-Up Programming & Operation
WARNING! Sudden Movement Hazard. The drive may start unexpectedly if the Run command is already applied when switching from
LOCAL mode to REMOTE mode when b1-07 = 1, resulting in death or serious injury. Be sure all personnel are clear of rotating
machinery.
The operation can be switched between LOCAL and REMOTE either by using the LO/RE key on the digital operator or
a digital input.
Note: 1. After selecting LOCAL, the LO/RE light will remain lit.
2. The drive will not allow the user to switch between LOCAL and REMOTE during run.
Using the LO/RE Key on the Digital Operator
1. Turn on the power to the drive. The initial display appears.
Press . The LO/RE light will light up. The drive is now in LOCAL.
2.
To set the drive for REMOTE operation, press the
Using Input Terminals S1 through S8 to Switch between LO/RE
The user can also switch between LOCAL and REMOTE modes using one of the digital input terminals S1 through S8
(set the corresponding parameter H1-
When setting the multi-function input terminals,
Note: 1. Refer to Parameter List on page 131
2. Setting H1-

◆ Start-Up Flowcharts

The flowcharts in this section summarize basic steps required to start the drive. Use the flowcharts to determine the most
appropriate start-up method for a given application. The charts are intended as a quick reference to help familiarize the
user with start-up procedures.
Flowchart Subchart
A –
A-1
– A-2
A-3
Note: To set up the drive using one of the Application Presets, refer to
58
Step
to "1").
for a list of digital input selections.
to 1 disables the LO/RE key on the digital operator.
Basic startup procedure and motor tuning
Simple motor setup using V/f mode
High-performance operation using Open Loop Vector (OLV) or Closed Loop Vector (CLV)
motor control
Setting up the drive to run a permanent magnet (PM) motor
key again.
Objective
Application Selection on page
YASKAWA ELECTRIC TOEP C710616 21C YASKAWA AC Drive - A1000 Quick Start Guide
Display/Result
YEC_c
DIGITAL OPERATOR JVOP-182 ALM
DRV
ommon
REV DRV FOUT
DIGITAL OPERATOR JVOP-182 ALM
DRV
REV DRV FOUT
YEC_
com-
LO
ESC
RE
mon
RESET ENTER
RUN STOP
63.
Page
59
60
61
62