Top Protective Cover - YASKAWA A1000 Series Quick Start Manual

Reattaching the Front Cover
2A0004 to 2A0081 and 4A0002 to 4A0044
Reverse the instructions given in
reattach the front cover. Pinch inwards on the hooks found on each side of the front cover while guiding it back into the
drive. Make sure it clicks firmly into place.
2A0110 to 2A0415 and 4A0058 to 4A0675
1.
Slide the front cover so that the hooks on the top connect to the drive.
Figure 25
Figure 25 Reattach the Front Cover (2A0110 to 2A0415 and 4A0058 to 4A0675)
2.
Once the hooks have connected to the drive, press firmly on the cover to make sure it locks into place.

◆ Top Protective Cover

Drive models CIMR-A 2A0004 to 0081 and 4A0002 to 0058 are designed with NEMA Type 1 specifications, and have
a top protective cover on the top. Removing this top protective cover voids the NEMA Type 1 conformance but still
keeps a protection degree in accordance with IP20 enclosure.
■ Removing the Top Protective Cover
Insert the tip of a straight-edge screwdriver into the small openings located on the front edge of the top protective cover.
Gently apply pressure as shown in the figure below to free the cover from the drive.
Note: Removing the top protective cover from a IP20/NEMA Type 1 enclosure drive voids the NEMA Type 1 protection but still keeps
IP20 conformity.
Figure 26
YASKAWA ELECTRIC TOEP C710616 21C YASKAWA AC Drive - A1000 Quick Start Guide
Remove the Front Cover (2A0004 to 2A0081 and 4A0002 to 4A0044) on page 32
Figure 26 Removing the Top Protective Cover
3 Electrical Installation
YEC_c
ommon
YEC_common
to
3
33