Start-Up Flowcharts; Start-Up Flowcharts; Flowchart A: Basic Start-Up And Motor Tuning - YASKAWA FSDrive-MV1000 Series Instructions For Use Manual

4.4 Start-Up Flowcharts

4.4

Start-Up Flowcharts

The flowcharts in this section summarize basic steps required to start the drive. Use the flowcharts to determine the most
appropriate start-up method for a given application. The charts are quick references to help familiarize the user with
startup procedures.
Flowchart Subchart
A –
A-1
–
A-2
u Flowchart A: Basic Start-Up and Motor Tuning
Flowchart A describes a basic start-up sequence that varies slightly depending on the application. Use drive default
parameter settings in simple applications that do not require high precision.
Figure 4.8
120
Basic start-up procedure and motor tuning
Parallel operation of multiple motors by V/f control
High-performance operation using Open Loop Vector (OLV) or Closed Loop Vector (CLV)
induction motor control
Install and wire the drive as explained in Chapters 1, 2, and 3.
Measure the insulation of the transformer.
Check from this display (control board) whether the status is normal.
Set the control mode in parameter A1-02.
b1-01/02 for frequency reference and Run command source selection
H1- , H2- , H3-
d1- for multi-step speed references if used
Enter the settings for acceleration/deceleration and S-curve characteristics at C1-
and C2- .
0: V/f
To
Flowchart A-1
Fine tune parameters. Adjust application settings if necessary.
Check the machine operation and verify parameter settings.
Drive is ready to run the application.
Figure 4.8 Basic Start-Up
Objective
START
Turn on the control power.
Set the basic parameters
, H4- for I/O terminal setting
Control Mode
A1-02 =
From Flowchart A-1, A-2
YASKAWA ELECTRIC TOEP C710687 02B FSDrive-MV1000 Instructions
2: OLV
3: CLV
To
Flowchart A-2
Page
120
121
122