YASKAWA A1000 Series Quick Start Manual page 54

4 Start-Up Programming & Operation
No. Display
11
12
13
14
<1> The STOP key has highest priority. Pressing the STOP key will always cause the drive to stop the motor, even if a Run command is active at
any external Run command source. To disable the STOP key priority, set parameter o2-06 to 0.
<2> The LO/RE key can only switch between LOCAL and REMOTE when the drive is stopped. To disable the LO/RE key to prohibit switching
between LOCAL and REMOTE, set parameter o2-01 to 0.
LED Screen Displays
■
Display
The drive has detected an alarm or error
Motor is rotating in reverse
• The drive is in the Drive Mode
• During Auto-Tuning
When the display shows the output
frequency
As illustrated in
this manual
<1> Refer to the DriveWorksEZ instruction manual for further information.
54
Name
ALM LED Light
FOUT LED Light
DRV LED Light
REV LED Light
Table 17 LED Screen Displays
Lit
ALM
DIGITAL OPERATOR JVOP-182
DRV
REV DRV FOUT
Refer to LED Screen Displays on page
Flashing
• When an alarm occurs
• oPE detected
• When a fault or error occurs during
Auto-Tuning
–
When DriveWorksEZ is used
–
ALM
ALM
DIGITAL OPERATOR JVOP-182
REV DRV FOUT
YASKAWA ELECTRIC TOEP C710616 21C YASKAWA AC Drive - A1000 Quick Start Guide
Function
54.
Normal state (no fault or alarm)
Motor is rotating forward
• The drive is in the Programming Mode
• The drive will not accept a Run
<1>
command
When a display other than the output
frequency monitor is shown.
DIGITAL OPERATOR JVOP-182
REV DRV
Off
ALM
FOUT