YASKAWA A1000 Series Quick Start Manual page 30

3 Electrical Installation
Reattaching the Terminal Cover
Power lines and signal wiring should pass through the opening provided.
page 42 and Wiring the Control Circuit Terminal on page 46
After all wiring to the drive and other devices is complete, reattach the terminal cover.
Figure 16
Figure 16 Reattaching the Terminal Cover on an IP20/NEMA Type 1 Enclosure Drive
CIMR-A 2A0110 to 0415, 4A0058 to 0675 (IP00 Enclosure)
■
Removing the Terminal Cover
1.
Loosen the screws
CAUTION! Do not completely remove the cover screws, just loosen them. If the cover screws are removed completely, the terminal
cover may fall off causing an injury.
<1> The following drives have three screws on the top of terminal cover.
-CIMR-A 2A0250 to 2A0415
-CIMR-A 4A0208 to 4A0675
Figure 17
2.
Pull forward on the terminal cover to free it from the drive.
Figure 18
30
Connect ground wiring first,
followed by the main circuit,
and then wire the control circuit.
Power lines and signal wiring
exit through the opening provided.
on the terminal cover, then pull down on the cover.
<1>
Figure 17 Removing the Terminal Cover on an IP00 Enclosure Drive
Figure 18 Removing the Terminal Cover on an IP00 Enclosure Drive
Refer to Wiring the Main Circuit Terminal on
for details on wiring.
YEC_common
YASKAWA ELECTRIC TOEP C710616 21C YASKAWA AC Drive - A1000 Quick Start Guide
YEC_common
YEC_common