Wpa2 Key-Caching Holdtime; Wep Key; Wep Key Type - D-Link DWL-8500AP Command Reference Manual

CLI Command Reference

wpa2 key-caching holdtime

This command configures the length of time a PMK will be cached by an AP for either client
roaming or key forwarding.
Default
Format
Mode
0-1440
no wpa2 key-caching holdtime
The version of this command sets the WPA2 key caching hold time to its default value.
no
Format
Mode

wep key

This command configures up to 4 static WEP keys for the network. The configured keys are
used when the network security mode is set to WEP shared key, according to the configured
WEP transfer key index. The number of characters required depends on the configured WEP
key type and length.
Format
Mode
1-4
value
no wep key
The version of this command removes the corresponding WEP key configuration.
no
Format
Mode

wep key type

This command configures the WEP key type for the network. The configured key type is used
when the network security mode is set to WEP shared key. The WEP key type affects the
166 © 2001- 2008 D-Link Corporation/D-Link Systems, Inc. All Rights Reserved.
10
wpa2 key-caching holdtime <0-1440>
Network Config
WPA2 key caching hold time in minutes.
no wpa2 key-caching holdtime
Network Config
wep key <1-4> <value>
Network Config
A valid WEP key index
The WEP key itself, entered in ASCII or HEX format. The following list
shows the number of keys to enter in the field:
64 bit —ASCII: 5 characters; Hex: 10 characters
128 bit —ASCII: 13 characters; Hex: 26 characters
152 bit —ASCII: 16 characters; Hex: 32 characters. For more information,
please see the "Static WEP" table in the D-Link Unified Wired/Wireless
Access System WLAN Switching Administrator's Guide.
no wep key <1-4>
Network Config