Omron RX2 Series User Manual page 511

Multistage Position Switching Function
By combining 076 to 079 ([CP1] terminal to [CP4] terminal), the multistage position commands 0 to 15
can be switched.
For setting the position command, use the multistage position command 0 to 15 ([AE-20] to [AE-50]).
When there no terminal assignments, the multistage position command 0 ([AE-20]) becomes the posi-
tion command.
Position command
Multistage position 0
Multistage position 1
Multistage position 2
Multistage position 3
Multistage position 4
Multistage position 5
Multistage position 6
Multistage position 7
Multistage position 8
Multistage position 9
Multistage position 10
Multistage position 11
Multistage position 12
Multistage position 13
Multistage position 14
Multistage position 15
Precautions for Correct Use
• When inputting the multistage position command, the waiting time until the terminal input is
fixed can be set. The transition state before the input is fixed can be prevented from being
adopted as the input.
• With the [CA-55] multistage input fixing time, the fixing time can be adjusted. Finally, after the
[CA-55] setting time passes without any changes of the input, the data is fixed. (Note that a
longer fixing time causes a bad performance of the input response.)
Example using [CP1] to [CP3] as the input terminals
[CA-55] Zero fixing time
Position
command
CP1
CP2
CP3
High-function General-purpose Inverter RX2 Series User's Manual
CP4
OFF
OFF
OFF
OFF
OFF
OFF
OFF
OFF
ON
ON
ON
ON
ON
ON
ON
ON
[CA-55] Fixing time
7
3
1
[CA-55] Fixing time
CP3
OFF
OFF
OFF
OFF
ON
ON
ON
ON
OFF
OFF
OFF
OFF
ON
ON
ON
ON
5
4 4
8 Applied Settings
CP2 CP1
OFF OFF
OFF ON
ON OFF
ON ON
OFF OFF
OFF ON
ON OFF
ON ON
OFF OFF
OFF ON
ON OFF
ON ON
OFF OFF
OFF ON
ON OFF
ON ON
8 - 111
8