Changing Procedure Of The Sewing Pattern; Confirming The Pattern Shape - JUKI MEB-3810N Series Instruction Manual

6-9. Changing procedure of the sewing pattern

A
❶
B
❹
❺

6-10. Confirming the pattern shape

❷
A
❶
3) When you press –/BACKWARD key
until the sewing end is reached. When you keep the key held pressed, the feed continuously travels.
4) After you have confirmed the pattern shape, press Reset key
position.
If the START switch is pressed during confirmation of the pattern shape, sewing starts from the
position where the switch is pressed. So, be careful.
Before starting the sewing machine, close the front cover.
If the Sewing LED stays ON, press the
Ready key
1) Press – key
pattern number B you want to sew. (The number
of pattern which is not registered is not displayed.)
2) Press READY key
A and to make it possible to sew. At this time, the
presser foot comes down and the feed base and
needle bar retrieve the respective origins.
The presser and the feed base operate.
Be careful that hands or fingers are not being
caught in them.
1) Press READY key
A and to make it possible to sew. At this time, the
presser foot comes down and the feed base and
needle bar retrieve the respective origins.
The presser and the feed base operate.
Be careful that hands or fingers are not being
❼
caught in them.
2) Operate the Presser foot switch to lower the presser
❻
foot.
❻ or +/FORWARD key
❷ to bring the feed to the material setting
– 50 –
❶
to turn it OFF.
❹ or + key ❺ to select the
❶ to light up sewing LED
❶ to light up sewing LED
❼, the feed travels stitch by stitch