JUKI MEB-3810N Series Instruction Manual page 109

Note 1 : Set the thread tension within the range of 0 ≦ thread tension ＋ compensation value of thread
tension ≦ 200.
Note 2 : L = cut length ＋ taper bar length ＋ Crosswise compensation of left eyelet ＋ Crosswise com-
pensation of left parallel section ＋ compensation of number of stitches at sewing end
Set the above length within the range described in the table below.
Type
MEB3810J00/MEB3810C00
MEB3810J01/MEB3810C01
Note 3 : Set the data within the range below.
Sewing speed － (minus) eyelet reduced speed ≧ 400
Number of stitches of slant taper bar ≦ number of stitches of taper bar
Compensation of number of stitches of right taper bar ≦ number of stitches of taper bar
–14 ≦ compensation of turning ＋ compensation of turning at parallel section ≦ 14
–1.2 ≦ cut space ＋ compensation of left cut space ≦ 1.2
Note 4 : If you replace the MAIN PWB and/or INT PWB, carry out the model setting. At this time, patterns of
pattern numbers 1 to 89 are not deleted. Refer to the Engineer's Manual for the model setting.
Thread trimming type
Needle thread trimming type
General thread trimming type
– 106 –
J type, C type
10 ≦ L ≦ 38 (mm)
10 ≦ L ≦ 34 (mm)