JUKI MEB-3810N Series Instruction Manual page 16

1. Lift the sewing machine head with four or more people by holding the sections marked with
dotted circle as shown in the figure.
2. Do not hold hinge stopper ❻, bottom ❺ of bottom cover D and depressed portion E on the
side face.
❺
❻
E
3. When putting the machine head on the bottom cover stays, carefully prevent handle ❼ and INT
cover ❽ from coming in contact with table ❶. In addition, do not place the wiring and piping
between INT cover ❽ and table ❶.
❾
❺
D
❶ ❾



– 13 –
E
Wiring, piping
❶
❶
❼
4) Lifting table ❶, join table ❶, bottom cover
stay (front) ❷ and bottom cover stay (rear)
❸ with eight bolts ❾, eight plain washers
, eight spring washers  and 16 nuts
 .
The bolt ❾ is M8 carriage bolt length
of which is 70 mm. The dimensions
of the plain washer  are "φ30
xφ8.5 x t2". Spring washer  is for
M8 and nut  is M8 (class 1).
Bolts ❾, plain washers , spring
washers  and nuts  are sup-
plied with the kit for semi-sunken
type machine head (part number:
40157881).
❽