Setting The Needle Throwing Width At The Upper Section Of Eyelet Bar; Setting The Reduced Sewing Speed For Straight/Round Bar; Setting The Sewing Speed; Setting The Reduction Speed Of Eyelet - JUKI MEB-3810N Series Instruction Manual

7-33. Setting the needle throwing width at the upper section of
eyelet bar

7-34. Setting the reduced sewing speed for straight/round bar

7-35. Setting the sewing speed

7-36. Setting the reduction speed of eyelet

The needle throwing width at the upper section of
eyelet bar is set.
Change the stitch width by operating the feed base
along with the needle throwing operation.
❼
Set the knife number by means of –/BACKWARD key
❻ or +/FORWARD key
❻
The needle throwing width can be set in the range of
2.5 ± 1.0 mm in increments of 0.1 mm.
The reduced sewing speed is set, which is used as
a target of speed reduction when you want to reduce
the sewing speed for straight/round bar.
❼
Set the knife number by means of –/BACKWARD key
❻ or +/FORWARD key
❻
The speed reduction can be set in increments of 100
sti/min within the range from –600 to 0 sti/min.
Set the sewing speed of the whole sewing.
Set the knife number by means of –/BACKWARD key
❻ or +/FORWARD key
❼
The sewing speed can be set 400 sti/min to 2,500 sti/
min in the increments of 100 sti/min.
❻
Set the reduction speed when the sewing speed of eyelet
section is desired to be reduced.
Set the knife number by means of –/BACKWARD key
❻ or +/FORWARD key
❼
The speed can be set –600 sti/min to 0 sti/min in the
increments of 100 sti/min.
❻
− 63 −
❼ .
❼ .
❼ .
❼ .