JUKI MEB-3810N Series Instruction Manual page 24

[For the needle thread clamp unit]
❷
❶
Table-fixed type
Table-fixed type
2) For the table-fixed type machine head, install manifold mounting plate ❷ which has been assembled in 1)
on table ❹ with two setscrews ❺ and two washers ❽. For the semi-sunken type machine head, install it
on bottom cover stay (rear) ❻ with two setscrews ❼.
Setscrew ❺ is M5 50-mm long pan head screw. Setscrew ❼ is M5 12 mm long pan head screw with
washer.
3) Attach plug ❾ to manifold asm. ❶ for the needle
thread clamp at the locations shown in the figure
at left.
For one of plugs ❾, remove No. 39 of the manifold
asm. and attach the plug instead. (Pipe is connect-
ed to No.39.)
❷
❸
Semi-sunken type
❺
❽
❷
❶
❾
1) Install manifold asm. ❶ for the
❸
❶
❹
Semi-sunken type

A
B
4) Connect connector A of standard manifold  and
connector B of manifold asm. ❶ for the needle
thread clamp.
– 21 –
needle thread clamp on manifold
mounting plate ❷ with four set-
screws ❸.
Setscrew ❸ is M4 hexa-
gon socket head screws of
which is 30 mm.
❻
❷
❼
❶