Installing The Poly Oiler; Installing The Operation Panel - JUKI MEB-3810N Series Instruction Manual

3-7. Installing the poly oiler

❺
❹
❼
❺
❻

3-8. Installing the operation panel

❺
❷
❷
❶
❸
❼
❺
❼
❼
❶
❻
❽
❶
❸
❹
– 19 –
1) Place the sewing machine in its home position.
2) nstall oil drain cock ❶, oil seal ❷ and washer ❸
on bottom cover ❺ with four setscrews ❹.
3) Raise the sewing machine.
4) Drive spring pin ❼ of bottom cover ❺ into bottom
cover ❺ until it is almost flush with bottom cover
❺.
Take care not to crack bottom cover ❺ when
driving in spring pin ❼.
5) Make a knot in the oil wick ❻ (ø2.5 mm). Insert oil
wick ❻ (ø2.5 mm) into spring pin ❼ of bottom cover
❺ until its end comes from oil drain cock ❶.
At this time, insert oil wick ❻ (ø2.5 mm) supplied
as accessories into the slit in spring pin ❼.
6) Install poly oiler ❽ on oil drain cock ❶.
Refer to "3-6. Raising and returning the
sewing machine" p. 16
return the sewing machine.
1) Fix operation panel installing plate ❶ on the table
at a desired location near its right end with four
wood screws ❷.
2) Put the cable of operation panel ❺ through hole
❹ in the table.
3) Fix operation panel ❺ on operating panel mounting
plate ❶ with three setscrews ❸.
Wood screw ❷ has the nominal diameter
of 3.8 mm and a length of 20 mm. Setscrew
❸ is an M4 round head screw with washer
and has a length of 16 mm.
when you raise or