JUKI MEB-3810N Series Instruction Manual page 106

No. Function
After-cut knife temporary stop selection
21
Cloth opening mechanism selection for straight
22
bar pattern
Front setting position
23
Needle thread clamp unit operation selection
24
Number of stitches to lift needle thread
25
clamp unit
Travel amount of needle thread clamp unit
26
LED lamp dimming setting
30
Selection of needle thread clamp unit opening
31
amount
Needle thread clamp unit lowering timing at
32
the end of sewing
Needle thread tension when the needle thread
33
clamp trims the needle thread.
Needle thread tension when the needle thread
34
clamp draws the needle thread
Description
Whether or not the machine is stopped before the after-cut
knife operates and the cloth cutting knife is operated by means
of the start switch is selected
0 : Normal operation
1 : The sewing machine automatically stops before the
after-cut knife operates, and the knife is operated by
means of the start switch.
Whether or not the sewing of a pattern including the straight
bar is performed with the cloth opening mechanism held
opened.
0 : Normal operation
1 :
Material is placed on the sewing machine with the cloth
opening mechanism held opened.
Position relative to the origin is set when "front position" is
selected for No. 12 is set.
(When the needle thread clamp unit is selected as an option)
Selection of whether the needle thread clamp unit is operated
0 : Not operated
1 : Operated (needle thread is clamped with the feed
stopped)
2 : Operated (needle thread is clamped without the feed
stopped)
(When the needle thread clamp unit is selected as an option)
The number of stitch at which the needle thread clamp unit
goes up is set.
(When the needle thread clamp unit is selected as an option)
The distance (unit : mm) by which the needle thread clamp unit
travels from the end of sewing, before the unit is closed is set.
LED lamp brightness is set with percentage (%)
(When the needle thread clamp unit is selected as an option)
0 : Goes up with opened when going up at the start of sewing
1 : Goes up with closed when going up at the start of sewing
(When the needle thread clamp unit is selected as an option)
The number of needle entry at which the needle thread clamp
unit comes down at the end of sewing is set.
(When the needle thread clamp unit is selected as an option)
The needle thread tension value when the needle thread
clamp operates to trim the needle thread is set.
(When the needle thread clamp unit is selected as an option)
The needle thread tension value of the needle thread clamp
unit when it operates to draw the needle thread after it has
been trimmed is set.
– 103 –
Setting Setting Initial
range unit value
0 to 1 - 0
0 to 1 - 0
0 to 54 1mm 22
0 to 2 - 1
0 to 20 1 stitch 14
0 to 40 1mm 10
0 to 100 5% 100
0 to 1 - 1
1 Needle
0 to 4 3
entry
0 to 200 1 2
0 to 200 1 150