Performing Threading; How To Use The Counter - JUKI MEB-3810N Series Instruction Manual

6-5. Performing threading

WARNING :
Turn OFF the power after operation of steps 1) and 2), and replace needle, thread, cloth cutting
knife or hammer.
This operation cannot be carried out immediately after power-on. Carry out the following operation
after the origin retrieval of the feed bar/needle bar by pressing once the Ready key
❷
❶

It is recommended to perform installing/
removing the presser unit after operating
the aforementioned step 1) and turning OFF
the power.

6-6. How to use the counter

❷
E
❾
The counter can be used as DOWN counter as well. Refer to
counting)" p. 76
C
❼
❻
for the procedure.
1) Press Threading key
① The presser foot comes down.
② In the case memory switch No. 12 "material setting
position selection" is set to the front side, the feed
base travels backward (to origin position).
③ The needle bar turns by 180 degrees of an angle
to allow threading of the needle bar from the front
of the machine head.
2) Press Threading key
the needle bar returns to its origin.
3) The parts described in the aforementioned steps
① to ③ described above are returned to the home
position by pressing Reset key
The presser and the feed base operate.
Be careful that hands or fingers are not being
caught in them.
The counter has been set to UP counter in
the state of delivery.
1) Press Counter key
LED E. The count value C is displayed on the LED.
2) Every time the sewing machine completes one
cycle stitching, the value increases by 1 count.
3) The counter value C can be changed with BACK-
WARD key
❼.
4) Press RESET key
value to "0".
5) When you press Counter key
Counter LED E stays on, the display on the LED is
restored to the normal display.
"9-5. Changing over the counter (DOWN
– 47 –
❶
.
 again. Then, only
❷.
❾ to light up Counter
❻ or +/FORWARD key
❷ to return the counter
❾ while
.