Copying The Pattern Data - JUKI MEB-3810N Series Instruction Manual

9-7. Copying the pattern data

In this step of procedure, the pattern data is to be copied.
❶
❶
B
❺
❹
② In the case the destination pattern data is
registered
③ At the time of confirming the overwrite
❷
❶
❸
❼
❻
Step of operation
described in 2)
❸
C
❼
❻
− 77 −
If the Sewing LED stays ON, press the
Ready key
1) Press Mode key
screen.
Press –/BACKWARD key
❼ to display "CoPy".
WARD key
2) Press Ready key
data copying screen.
3) Press – key ❹ or + key
source pattern number to be copied which is dis-
played on the 2-digit LED B.
(The number for which no pattern is registered is
not displayed.)
4) Press –/BACKWARD key
❼ to select the destination
WARD key
pattern number of copying which is displayed on
the 4-digit LED C.
Indication ① is displayed when the destination pat-
tern data is not registered, or ② is displayed when
it is registered. Pattern number can be set at "1" to
"89".
5) Press Ready key
from the source to the destination.
If you press Mode key
copying is cancelled.
6) When you press Ready key
destination pattern number is present, confirmation
screen ③ is displayed. When you press Ready key
❶, the present data is overwritten. If you
press Reset key
7) Press Mode key
to return the screen to the normal display.
Pattern numbers 90 to 99 cannot be over-
written since they are standard patterns.
❶ to turn it OFF.
❸ to display the mode setting
❻ or +/FOR-
❶ to display the pattern
❺ to select the
❻ or +/FOR-
❶ to copy the pattern data
❸, the pattern data
❶ when the
❷, the overwrite is cancelled.
❸ while "CoPy" is displayed