JUKI MEB-3810N Series Instruction Manual page 45

No. Name
 + / FORWARD
key

THREAD
TENSION
LED
 THREAD
TENSION key
 COUNTER
LED
 COUNTER
key
 THREADING
key

KNIFE ON/
OFF key
 BEFORE-CUT
KNIFE LED

A F T E R - C U T
KNIFE LED
 DATA LED
 DATA key
Note 1 : The key is disabled immediately after the power-on. It is enabled after the completion of feed-base
origin retrieval by pressing the ready key once.
Note 2 : In the case Data No. 3 of the pattern data (before-cut knife/after-cut knife) is set to "without knife",
the Before-cut knife/After-cut knife LEDs stays off.
Note 3 : These keys are enabled only in the setting state where the sewing LED goes out.
(Reference) The 2-digit LED and 4-digit LED display data as shown below.
Numeric values 0
Digital display
Characters A
Digital display
Characters N
Digital display
This key is used to increment the set value of data or the count value on
the counter when setting the data. It is used to move the feed forward by
one stitch in the pause state.
This LED lights up when displaying/setting the needle thread tension.
This key is used to display/set the needle thread tension.
This LED lights up when displaying/setting the counter.
This key is used to display/set the set value of the counter.
This key is used to place the machine in the threading mode. (Note 1)
This key is used to change over the operation status of the cloth cutting
knife between enable/disable. The before-cut knife /after-cut knife LED
lights up/goes out. (Note 2)
This LED lights up when the cloth cutting knife operates as before-cut
knife.
This LED lights up when the cloth cutting knife operates as after-cut knife.
This LED lights up when displaying/setting the data. (Note 3)
This key is used to display/set the pattern data. (Note 3)
1 2 3 4 5
B C D E F
O P Q R S
Description
6 7 8 9
G H I J
T U V W
– 42 –
K L M
X Y Z