Setting The Cut Space; Setting The Eyelet Space; Knife Position Compensation - JUKI MEB-3810N Series Instruction Manual

7-6. Setting the cut space

Clearance

7-7. Setting the eyelet space

7-8. Knife position compensation

❼
❻
Clearance
❼
❻
Clearance
❼
+
❻
– –
− 54 −
Set the clearance where the knife drops in the parallel
section.
Set the knife number by means of –/BACKWARD key
❻ or +/FORWARD key
The space can be set –1.2 to 1.2 mm in the increments
of 0.1 mm.
Set the clearance where the knife drops in the eyelet
section.
Set the knife number by means of –/BACKWARD key
❻ or +/FORWARD key
can be set –1.2 to 1.2 mm in the increments of 0.1 mm.
Correct the slip between the position of knife and
sewing position.
Set the knife number by means of –/BACKWARD key
❻ or +/FORWARD key
Setting can be performed – 0.7 to 0.7 mm in the incre-
ments of 0.1 mm.
When the knife position in terms of the stitches is de-
sired to be placed in the rear side, set "+" (plus) value,
and in the front side, set "－" (minus) value.
❼ .
❼ .The space
❼ .