Setting Procedure Of The Sewing Data - JUKI MEB-3810N Series Instruction Manual

7. SETTING PROCEDURE OF THE SEWING DATA

In the case the sewing machine stops with its needle-bar rested in any position other than the upper
end when the READY key
In this case, turn the hand pulley to move the needle bar to its upper stop position. Error (E030)
will disappear when the upper stop position is reached. In this state, press the READY key
again to light up sewing LED A
In addition, the needle bar will automatically return to the upper stop position when you press the
READY key
as the needle bar rests at any position between the upper stop position and a point short of the
lower dead point.
For the standard sewing patterns No. 90 to No. 99, the sewing speed and the thread tension can be
changed. However, the pattern shape cannot be changed. To change the pattern shape, you have
to copy the pattern to a different pattern number.
Refer to "9-7. Copying the pattern data" p. 77
❶
B
❹
❺
A
❶
B
❹
❺
6) Press Data key
It is possible to prohibit the data setting from being changed in the aforementioned step 4) by setting
memory switch No. 16 "Data setting prohibition" to "1". Refer to
the procedure.
is pressed, Error (E030) will occur to stop the sewing machine.
.
even in the case the needle bar is not brought to its upper stop position as long
H
C
❼
❻
H

 while Data LED H stays ON to return the screen to the normal display.
for the procedure.
If the Sewing LED stays ON, press the
Ready key
1) Press – key
pattern number B sewing data of which you want
to change. (Any number to which the pattern data
is not registered is not displayed.)
2) Press Data key

The LED displays the set value of data.
3) Press – key
data number B to display the set value C of data.
4) Press –/BACKWARD key
❼ to set a new set value C of data.
key
5) Press Ready key
A. At this time, the sewing data is stored in memory.
At the same time, the presser foot comes down and
the feed base and needle bar retrieve the respective
origins.
1. If you change the pattern number with-
out pressing Ready key
the aforementioned step 5), or turn the
power off, the set value you have input
will not be stored in memory.
2. The presser and the feed base operate.
Be careful that hands or fingers are not
being caught in them.
− 51 −
❶
to turn it OFF.
❹ or + key ❺ to select the
 to light up Data LED H.
❹ or + key ❺ to select the
❻ or +/FORWARD
❶ to light up Sewing LED
"13. MEMORY SWITCH" p. 101
❶
in
for