In The Case Of The Semi-Sunken Type Machine Head - JUKI MEB-3810N Series Instruction Manual

(2) In the case of the semi-sunken type machine head

❶
❹
❺
❻
❸
❷
① Installing the table reinforcing plate
1) Fix two table reinforcing plates ❷ on the table ❶ with eight bolts ❸ , eight plain washers ❹ , eight spring
washers ❺ and 16 nuts ❻.
The bolt ❸ is M6 carriage bolt length of which is 60 mm. The dimensions of the plain washer ❹ are
"φ12.5 xφ6.4 x t1.6". Spring washer ❺ is for M6 and nut ❻ is M6 (class 1).
Bolts ❸, plain washers ❹, spring washers ❺ and nuts ❻ are supplied with the kit for semi-sunken
type machine head (part number: 40157881).
❶
Under-
side
❷
② Assembling the bottom cover stay (front)
1) Remove paper liners ❸ from two bottom rubbers
B ❶ and affix them on bottom cover stay ❷.
* Affix two right-side bottom rubbers B ❶ with shifted
to the left side (in the direction of the arrow) with
respect to slot A in bottom cover stay ❷.
1. Insert bottom rubbers B ❶ into the respective holes in bottom cover stay ❷ while holding them
so that their projecting side is faced downward.
2. Carefully check the location of mounting holes in left-side bottom rubbers B ❶.
Bolt rubber B ❶ is the head accessories. In addition, bottom cover stay ❷ are supplied with the kit
for semi-sunken type machine head (part number: 40157881).
❸
Paper
liner
❶
A
– 11 –
❸
❷
Under-
side
❶
❷
③ Assembling the bottom cover stay (rear)
1) Remove paper liners ❸ from two bottom rubbers
B ❶ and affix them on bottom cover stay ❷.
* Affix two right-side bottom rubbers B ❶ with shifted
to the right side (in the direction of the arrow) with
respect to slot A in bottom cover stay ❷.
❶
Paper
liner
❶
A