3-2. Installing the control box
❷
30 mm or more
3-3. Installing and connecting the power switch
1) Installing the power switch
❶
Install control box ❶ to the location illustrated in the
figure using four bolts ❷, four plain washers ❸ and
four spring washers ❹ and four hexagonal nuts ❺
supplied with the unit.
❸
❹
❺
❶
Fix power switch ❶ on the underside of the table with
two wood screws ❷.
❷
– 6 –
1. Install control box ❶ 30 mm or more
away from the stand. If control box ❶ is
located too close to the stand, the for-
mer can get hot or the sewing machine
can malfunction.
2. In the case the semi-sunken type ma-
chine head used, install the control box
after carrying out the procedure written
in
"3-9. Installing the regulator and the
manifold" p.
20.
Bolt ❷ is a cup head square neck bolt (M8;
Length: 70 mm) and nut ❺ is a hexagonal
nut (M8).
In the case the semi-sunken type machine
head used, install the control box after
carrying out the procedure written in
Installing the regulator and the manifold"
p.
20.
Wood screw ❷ has the nominal diameter of
5.1 mm and a length of 20 mm.
"3-9.