Installing The Foot Pedal Switch (Optional) - JUKI MEB-3810N Series Instruction Manual

3-12. Installing the foot pedal switch (optional)

DANGER :
To prevent personal injuries caused by electric shock hazards or abrupt start of the sewing
machine, carry out the work after turning OFF the power switch and a lapse of 5 minutes or more.
To prevent accidents caused by unaccustomed work or electric shock, request the electric expert
or engineer of our dealers when adjusting the electrical components.
The hand switch is provided on the standard type machine.
To use the optional foot pedal switch (part number: 40033831), connect it in the procedure described below.
When installing the foot pedal switch, the foot pedal switch junction cable asm. (part number: 40114433) is
also required. Refer to "11-6. Others" p. 98.
❶
❸
❷
❹
❺
A
B
C
1) Loosen the four setscrews in the control box to
remove cover ❶.
2) Fix earthing wire ❷ of the foot pedal switch at
location A of the control box.
Pass the earthing wire through cord exit
plate ❸. If not, it can be caught under the
cover when closing it.
3) Connect foot pedal switch junction cable ❹ to the
foot pedal switch cable (B) and connect the oppo-
site side of the junction cable to CN43 connector
on the PWB (C).
4) Fix the cable.
Loosen cable clip band ❺. Fix the foot pedal switch
cables (excluding earthing wire ❷) by means of
cable clip band ❺ together with other related ca-
bles.
DANGER :
It is very important to carefully connect the
cables to the correct connectors on the
PWB. Wrong connection poses a great risk.
Even in the case the optional foot pedal
switch is installed on the sewing machine,
the hand switch is still enabled. Carefully
operate the switches since the sewing
machine is activated by operating either
switch.
– 24 –