Number Of Stitches Of Sewing End Compensation; Turning Angle Compensation; Turning Angle Compensation At The Parallel Section - JUKI MEB-3810N Series Instruction Manual

7-9. Number of stitches of sewing end compensation

−
+

7-10. Turning angle compensation

7-11. Turning angle compensation at the parallel section

Number of stitches of sewing end can be increased at
the same sewing pitch.
Set the knife number by means of –/BACKWARD key
❼
❻
Turning angle of the eyelet section and of the parallel
section can be adjusted.
Set the knife number by means of –/BACKWARD key
❼
Setting can be performed –14˚ to 14˚.
❻
+
−
Turning angle of parallel section and bottom of eyelet
can be adjusted.
Set the knife number by means of –/BACKWARD key
❼
If the turning angle compensation is carried out the as
described in "7-10. Turning angle compensation", the
❻
turning angle at the parallel section of a buttonhole will
be adjusted in such a way as to add this set value to
+
the compensation set in 7-10.
It is possible to set the angle compensation in the range
−
of "–14˚ ≤ turning angle compensation + turning angle
compensation at the parallel section ≤ 14˚".
− 55 −
❻ or +/FORWARD key
–
Without bartack ....... 1 to 6 stitches
–
Taper bar ................. 1 to 6 stitches
–
Straight bar .............. 1 to 3 stitches
Round bar................–1 to the number of stitches of
round bar on the right side at the
beginning of sewing
Round bar 2.............0 stitch
❻ or +/FORWARD key
❻ or +/FORWARD key
❼ .
❼.
❼.