JUKI MEB-3810N Series Instruction Manual page 52

Sewing machine operation under each operation mode
(1) NORMAL mode (when the operation mode is set to "0" and the power is ON)
Operation is carried out under the normal operation mode where the cloth cutting knife is activated and a
sewing sequence such as sewing and thread trimming is carried out by operating the Presser foot switch
and the Start switch.
Before starting the sewing machine, close the front cover.
(2) MANUAL mode (when the operation mode is set to "1")
Operate the Presser foot switch to lower the presser foot. Then, the operation is carried out as described
below.
① In the case of the before-cut knife is selected, the feed base is brought to its origin, when it is not there
by operating the Start switch.
② In the case of the before-cut knife is selected, the cloth cutting knife is activated by operating the Start
switch.
③ The cloth open mechanism is opened by operating the Start switch.
④ The feed base is brought to the sewing starting position by operating the Start switch. Then, the buzzer
sounds.
⑤ Turn the pulley in the direction of the arrow. The feed base is travels stitch by stitch in conjunction with
the needle position. Keep the pulley turning until the sewing end position is reached. Then, the buzzer
sounds.It is also possible to move only the feed base by means of –/BACKWARD key
FORWARD key
Be sure to turn the handwheel in the normal direction since the feed mechanism does not perform
the receding operation even when the handwheel is turned in the reverse direction.
⑥ The feed base is brought to its origin and the needle thread trimming operation is carried out by operating
the Start switch.
⑦ When the after-cut knife is selected, the cloth cutting knife is activated by operating the Start switch.
⑧ For the general thread trimming type machine, the bobbin thread trimming operation is carried out by
operating the Start switch.
⑨ The needle bar is brought to its origin and the cloth open mechanism is closed by operating the Start
switch.
⑩ To terminate sewing before it is completed, press Reset key
position.
Before starting the sewing machine, close the front cover.
(3) STEP mode (when the operation mode is set to "2")
After you have lowered the presser foot by operating the Presser foot switch, the sewing machine operates in
the same way as described in steps ① to ④ and ⑥ to ⑩ under (2) MANUAL mode. Only step ⑤ is different
from the MANUAL mode. In the MANUAL mode, the feed base travels stitch by stitch by turning the pulley
by hand. On the other hand, in the STEP mode, the following operation is carried out by operating the Start
switch.
⑤ The sewing machine carries out the normal sewing operation and stops at the sewing end.
Before starting the sewing machine, close the front cover.
❼.
– 49 –
❷ to bring the feed base to the set
❻ or +/