7-21. Setting the length of taper bar
7-22. Setting the number of stitches of taper bar
7-23. Setting the offset of taper bar
❼
❻
Length
❼
❻
❼
❻
Offset amount
− 59 −
Set the length of taper bar.
Set the knife number by means of –/BACKWARD key
❻ or +/FORWARD key
The taper bar length can be set in increments of 1 mm
in the range from 3 to 15 mm.
Set the number of stitches of taper bar.
Set the knife number by means of –/BACKWARD key
❻ or +/FORWARD key
The number of stitches can be set according to the
taper bar length using the range of stitch length from
0.5 to 4 mm.
Example) When the taper bar length is 6 mm, the
number of stitches can be set in the range
from two to 12.
When the number of stitches is small, the
sewing speed is automatically reduced.
Set the offset amount from the center of taper bar.
Set the knife number by means of –/BACKWARD key
❻ or +/FORWARD key
The offset amount can be set 0.5 mm to 2.0 mm in the
increments of 0.1 mm.
❼.
❼.
❼.