First Edition • Third Printing
2-1
Platform
How to Remove the Platform
1 Separate the foot switch wiring quick
disconnect plug from the platform toeboard.
2 Open the platform control box.
Electrocution hazard. Contact with
electrically charged circuits could
result in death or serious injury.
Remove all rings, watches and
other jewelry.
3 Remove the platform control box mounting
fasteners, lower the control box and lay it off to
the side.
Component damage hazard.
Cables can be damaged if they
are kinked or pinched.
If your machine is equipped with
an air line to platform option, the
air line must be disconnected from
the platform before removal.
Part No. 41314
Platform Components
Genie Z-20/8N & Genie Z-20/8 & Genie Z-25/8
Section 7 • Repair Procedures
4 Raise the jib boom slightly and place
sawhorses under the platform. Lower the jib
boom just until the platform is resting on the
sawhorses.
Do not rest the entire weight of the
boom on the sawhorses.
5 Remove the platform mounting fasteners and
remove the platform.
Do not overtighten the platform
mounting fasteners during
installation.
7 - 9