How To Adjust The Function Ramp Rate Setting; Platform Components; Platform - Genie Z-80/60 Service And Repair Manual

Service and Repair Manual

Platform Components

6 Press the enter button to save the setting in
memory.
7 Press the enter or previous button on the
LCD screen until EXIT is displayed.
8 Press the plus button or minus button to
select YES and then press the enter button.
9 Continue to perform this procedure until the
machine function speed meets specification.
Refer to Specifications, Performance
Specifications.
How to Adj ust the Functi on R amp R ate Setti ng
How to Adjust the Function Ramp
Rate Setting
The ramp rate setting of a joystick controls the time
at which it takes for the joystick to reach maximum
output, when moved out of the neutral position. The
ramp rate settings of a joystick can be changed to
compensate for hydraulic pump wear to maintain
peak performance from the machine.
Note: Perform this procedure with the boom in the
stowed position.
Note: Use the following chart to identify the
description of each LCD screen control button used
in this procedure.
Plus Minus
1 Pull out the red Emergency Stop button to the
on position at both the ground and platform
controls.
2 Press and hold the enter button on the ground
control panel while turning the key switch to
platform controls. Hold the enter button for
approximately 5 seconds.
3 Press the plus button twice, then press the
previous button twice.
28
Previous Enter
4 Press the previous button until the function to
be adjusted is displayed.
5 Press the plus button to increase the ramp
rate or press the minus button to decrease the
ramp rate.
6 Press the enter button to save the setting in
memory.
7 Press the enter or previous button on the
LCD screen until EXIT is displayed.
8 Press the plus button or minus button to
select YES and then press the enter button.
Ramp Rate Specifications
Ramp rate (factory settings)
Turntable rotate
accelerate
decelerate
Primary boom up/down
accelerate
decelerate
Primary boom extend/retract
accelerate
decelerate
Secondary boom up/down
accelerate
decelerate
Secondary boom extend/retract
accelerate
decelerate
Drive
accelerate
decelerate to neutral
decelerate, change of direction
decelerate, coasting
decelerate, braking
decelerate, shift from low to high
speed
decelerate, shift from high to low
speed
September 2016
4 seconds
1.0 second
3 seconds
0.25 second
3 seconds
0.75 second
7 seconds
0.75 second
7 seconds
0.75 second
1.5 seconds
0.5 second
0.5 second
0.75 second
2 seconds
1 second
4 seconds
Part No. 1268556