Siemens SINUMERIK Series Function Manual page 98

Commissioning - TM54F
4.3 Canceling the commissioning mode
98
Press the "Confirm all TM54F" softkey to confirm the SI data of all TM54F
and to exit the commissioning mode. The actual checksum of all TM54F
is copied over to the reference checksum.
This softkey is only visible if there are several TM54F devices are in your
drive system.
2b. Objective: Undo changes
Press the "Reset (po)" softkey to undo all changes to the SI data. The
NCK and the complete drive system is then restarted.
2c. Objective: Remain in the commissioning mode
Press the "Cancel" softkey if you do not wish to exit the commissioning
mode.
The prompt is closed. The commissioning mode remains active.
Function Manual, 10/2015, 6FC5397-3EP40-5BA3
Safety Integrated