Diagnostics
7.4 TM54F
● Signal source, forced checking procedure (test stop)
Display of the set input terminal to start a test stop/forced checking procedure.
● Test cycle dynamization F-DO
Display of the defined time interval to check for fail safety.
● Automatic test stop when powering up
Display of the configuration of the test stop of F-DI and F-DO.
7.4.2
Inputs
The input terminals of the actual TM54F are shown in the the "Inputs" window. This involves
the following terminals:
● X521
● X522
● X531
● X532
These terminals are on the front side of the module. The terminals are displayed one above
the other in the window.
You can reach the lower terminals by scrolling (page up/page down). Alternatively, using the
"Select terminal" softkey, you can open a selection and select the terminal that is to be
displayed in the window.
The following information is provided in the "Inputs" window:
Figure 7-5
168
Diagnostics: TM54F inputs
Function Manual, 10/2015, 6FC5397-3EP40-5BA3
Safety Integrated