Mazda CX-9 Grand Touring 2009 Manual page 829

VCTADVERR2
VOLTAGE SENSOR SPECIFICATION CHART
Other
KOEO Hot Idle 48 KM/H (30MPH)
ETCVREF 5
VREF 5
VPWR VBAT
KAPWR VBAT
PCM CONFIGURATION [MZI-3.7]
NOTE:
Use the IDS (laptop PC) because the PDS (Pocket PC) does not support
the PCM CONFIGURATION.
1. Connect the M-MDS to DLC-2.
2. After the vehicle is identified, select the following items from the initialization screen of the M-MDS.
When using the IDS (laptop PC)
1. Select the "Module Programming".
3. Then, select the "Programmable Module Installation", "PCM" from the screen menu.
4. Select "PCM" and perform procedures according to directions on the M-MDS screen.
5. Retrieve DTCs by the M-MDS, then verify that there is no DTC present.
If a DTC(s) is detected, perform the applicable DTC inspection. (See DTC TABLE [MZI-3.7] .)
Fig. 8: Identifying DLC-2 Connector
Courtesy of MAZDA MOTORS CORP.
POWER STEERING PRESSURE (PSP) SWITCH INSPECTION [MZI-3.7]
CONTINUITY INSPECTION
1. Disconnect the PSP switch connector.
2008 Mazda CX-9 Grand Touring
2008 ENGINE Control System (MZI-3.7) - Mazda CX-9
0 0.06 -0.43
Measured/PID Values
5 5
5 5
VBAT VBAT
VBAT VBAT
0
89 KM/H (55MPH)
5
5
VBAT
VBAT
DEG
Units Measured/PID
DCV
DCV
DCV
DCV