D-Link DGS-1510 Series Web Ui Reference Manual page 352

DGS-1510 Series Gigabit Ethernet SmartPro Switch Web UI Reference Guide
Unit
From Port / To Port
Type
Action
Level Type
PPS Rise
PPS Low
Click the Apply button to accept the changes made.
After selecting the Kbps option as the Level Type, the following parameters are available.
The fields that can be configured are described below:
Parameter
KBPS Rise
KBPS Low
Click the Apply button to accept the changes made.
After selecting the Level option as the Level Type, the following parameters are available.
Select the switch unit that will be used for this configuration here.
Select the appropriate port range used for the configuration here.
Select the type of storm attack that will be controlled here. Options to
choose from are Broadcast, Multicast, and Unicast. When the action
is configured as the shutdown mode, the unicast refers to both known
and unknown unicast packets; that is, if the known and unknown
unicast packets hit the specified threshold, the port will be shutdown.
Otherwise, unicast refers to unknown unicast packets.
Select the action that will be taken here. Options to choose from are
None, Shutdown, and Drop. Selecting None specifies not to filter the
storm packets. Selecting Shutdown specifies to shut down the port
when the value specified for rise threshold is reached. Selecting Drop
specifies to discards packets that exceed the risen threshold.
Select the level type option here. Options to choose from are PPS,
Kbps, and Level.
Enter the rise packets per second value here. This option specifies the
rise threshold value in packets count per second. This value must be
between 0 and 2147483647 packets per second. If the low PPS value
is not specified, the default value is 80% of the specified risen PPS.
Enter the low packets per second value here. This option specifies the
low threshold value in packets count per second. This value must be
between 0 and 2147483647 packets per second. If the low PPS value
is not specified, the default value is 80% of the specified risen PPS.
Figure 9-84 Storm Control (Kbps) window
Description
Enter the rise KBPS value used here. This option specifies the rise
threshold value as a rate of kilobits per second at which traffic is
received on the port. This value must be between 0 and 2147483647
Kbps.
Enter the low KBPS value used here. This option specifies the low
threshold value as a rate of kilobits per second at which traffic is
received on the port. This value must be between 0 and 2147483647
Kbps. If the low KBPS is not specified, the default value is 80% of the
specified risen KBPS.
344